Guten Abend zusammen,
mein Fehlerspeicher meldet eine "Leerlaufsteller Fehlfunktion".
Was mache ich am besten?
Liebe Grüße,
Kobold
Guten Abend zusammen,
mein Fehlerspeicher meldet eine "Leerlaufsteller Fehlfunktion".
Was mache ich am besten?
Liebe Grüße,
Kobold
Morsche, beim M111 erstmal Kabelbaum prüfen.
Was macht den der Wagen, geht er aus- springt er net an?
Hallo Heinrich,
der wagen läuft anfangs nicht ohne gas... während er wärmer wird kann ich das fuß vom gas nehmen und er läuft von alleine, an Ampeln kann er aber mal ausgehen und fängt an zu schwanken... zum glück fahre ich hauptsächlich Autobahn wo alles normal wirkt.
gruß, Kobold
LED pulse code 8? or scanner code 022?
reason - wire throttle, throttle motor of wear. it often. You can treat yourself.
der Fehler Speicher hat mir mit der LED 7x geblinkt also "Leerlaufsteller Fehlfunktion"
7 0I7 Drive actual value potentiometer (M16/6r2) in
idle speed control actuator implausibly high
AD07.51-P-6002-01A
AD07.51-P-6002-02A
7 0I8 Drive actual value potentiometer (M16/6r2) in
idle speed control actuator implausibly low
AD07.51-P-6002-01A
AD07.51-P-6002-02A
7 0I9 Drive actual value potentiometer (M16/6r2) in
idle speed control actuator - loose contact
AD07.51-P-6002-01A
AD07.51-P-6002-02A
you need to check the wires on the throttle. especially the wire that goes from pin 2 (throttle connector) and check crack soldering on the board of the throttle ... error on the potentiometer 2.
Its signal can be seen as you apply 5V to pins 3 (+) and 7 (-), and measure the voltage between 7-2. At rest there 3.7V and changed if moving the lever under the plastic cover throttle.